Hitachi Koki DS 14DVF Safety & Instruction Manual page 15

Cordless driver drill
Table of Contents

Advertisement

Available languages

Available languages

1. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown in Fig. 4. Make sure it contacts the
bottom of the battery charger.
<DS12DVF>
Battery
Pilot Lamp
2. Insert the plug of battery charger into the receptacle.
3. Charging
When the plug of battery charger has been inserted into the receptacle, charging will
commence and the pilot lamp will light on.
NOTE: If the pilot lamp dose not light, pull out the plug from the receptacle and check
if the battery is properly mounted.
In approx. one hour, when the battery is fully charged, the pilot lamp will go out.
NOTE: The battery charging time becomes longer when a temperature is low or the
voltage of the power source is too low.
When the pilot lamp does not go off even if more than four hour has passed
after start of the charging, stop the charging and contact your HITACHI
AUTHORIZED SERVICE CENTER.
4. Disconnect battery charger from the receptacle.
Fig. 4
WARNING:
Do not use the electrical cord if damaged. Have it
repaired immediately.
<DS14DVF>
Battery
Pilot Lamp
English
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ds 12dvf

Table of Contents