Cisco 7940 User Manual page 8

Dialing:
ReDial:
Hold:
Call Park:
Call Back:
With Cisco phones you have several different options for placing a call.
Off-hook dialing:
Predialing:
On-hook dialing:
This will automatically dial the last called number from your phone.
To Activate:
Allows you to place a call on hold.
To Activate:
To Return to the call:
This allows you to park an active call and then retrieve it using another phone
within your phone system.
To Activate: 1. During an active call, press the More Softkey
until you see the Park tab.
2. Press the Park Softkey to park the call. The
LCD displays the number where the call is
parked.
3. Make a note of the Call Park number and hang
up.
4. To retrieve the parked call, go to any phone on campus
and dial the Call Park number.
Notifies you that a previously dialed on-campus number (with a busy tone) is
now available.
To Activate: 1. When you receive a busy tone, press the
CallBack Softkey. The phone will indicate that
Callback has been initiated against the DN just
called. You are now free to make any other call.
2. Once the far end goes idle your set will play a
special ring tone to let you know that the DN
has become available and a new "Dial" Softkey
will be displayed. Press it and it will redial the
original number for you.
Lift handset and dial the number.
Dial the number you want to call and either pick up
the handset which then initiates the call or press the
Dial Softkey (on a 7960 only) and this initiates the
call on the speakerphone if the handset is NOT
picked up.
Press the Speaker button and then dial (NOT offered
on 7912 set).
Lift handset and press the Redial Softkey.
During a call, press the Hold Softkey.
Press the Resume Softkey.