Page 1
Installation Built-In Dishwasher Instructions If you have questions, 1-800-4-MY-HOME®(US) at: www.Kenmore.com call visit website www.Sears.com BEFORE YOU BEGIN IMPORTANT MUST - The dishwasher be installed Read these instructions completely allow for future removal from the enclosure if service carefully. is required. If you received a damaged dishwasher,...
Installation Preparation PARTS SUPPLIED: Two#8 Phillips flat head wood screws, 5/8" long to secure dishwasher to underside of countertop (in literature package). Two Phillips head, color matched toekick screws (in 2 Wood Screws 2 Color Matched Screw Type literature package). Toekick Screws Hose Clamp MATERIALS YOU WILL NEED:...
Page 3
Installation Preparation PREPARE DISHWASHER ENCLOSURE • The dishwasher must installed so that drain hose is no more than 10 feet in length proper drainage. • The dishwasher must be fully enclosed on the top, sides back, must support part of the enclosure. CLEARANCES: When /C0unteR0p 32.5"...
Installation Preparation PREPARE ELECTRICAL WIRING WARNING ", FORPERSONAL SAFETY: Remove house fuse or open circuit breaker before beginning installation. Do not use an extension cord or 1-1/2" Dia, adapter plug with this appliance. tole (Max.) Electrical Requirements 120V,60 Hz., from •...
Installation Instructions PREPARE HOT WATER LINE BEFOREYOU BEGIN • The line may enter from either side, rear or floor within the Locate and set aside the package containing shaded area shown in Figure F. 2 Phillips head countertop mounting screws and •...
Page 6
Installation Instructions lSTEP ADJUST LEVELING LEGS STEP 4 INSTALL 90" ELBOW Move • the dishwasher close to the installation location • Wrap 90 ° elbow with thread seal tape. • Install a 90 ° elbow onto water valve. it on its back.
Installation Instructions STEP 7 SLIDE DISHWASHER STEP 5 pOSITION WATER LINE AND HOUSE WIRING PARTIALLY INTO CABINET DO NOT PUSH AGAINST FRONT PANEL WITH • Position water supply line and house wiring on the floor KNEES. DAMAGE WILL OCCUR. the opening to avoid interference with base of dishwasher and components under dishwasher,...
Installation Instructions STEP 8 POSITION DISHWASHER UNDER COUNTERTOP • Check to be sure that wires secure under dishwasher bR_ P °Sai_ ipl_gD_Soht_ rasher pinched or in contact with door springs or other dishwasher components. With Hands TIP: Check tub insulation blanket, if equipped.
Installation Instructions I STEP 10 ]SECURE DISHWASHER STEP 11 CONNECT WATER TO COUNTERTOP OR CABINET SUPPLY In this step will need the 2 Phillips special head screws Connect water supply to 90 ° elbow. aside prior to Step 1. The dishwasher must secured to the...
Installation Instructions [STEP 12 ]CONNECT DRAIN LINE DRAIN LINE INSTALLATION FOLLOW ALLLOCAL CODES AND ORDINANCES. • Connect drain line to air gap, waste tee or disposer using either previously determined method. 3/4" The drain hose molded end will fit 5/8", or 1"...
Installation Instructions {STEP 13 ]CONNECT POWER STEP 14 PRE-TEST CHECKLIST SUPPLY Review this list after installing your dishwasher avoid charges service call that is not Skip this step if equipped with power cord. covered your warranty, Verify that power is turned off at the source. Check to be sure power is OFF.
Installation Instructions [STEP 15 ]DISHWASHER WET TEST STEP 16 REPLACE TOEKICK Turn on power supply (or plug power cord into outlet, equipped), Turn dial to Normal "Wash" position. Close door. Check to be sure that water enters dishwasher. water does enter dishwasher, check...