Connect To Water Supply - Kenmore Dishwasher Installation Instructions Manual

Align front of dishwasher door panel with front of cabinet doors.
You may need to adjust alignment to be even with your
cabinets.
Check that leveling legs are firmly against the floor. Close and
latch the door, and place level against the front panel. Check
that dishwasher is centered from front to back in the opening. If
needed, adjust leveling leg until dishwasher is plumb. Repeat for
other side of dishwasher.
Helpful Tip: Push up on front of dishwasher to raise dishwasher
off the ground to adjust front legs. With some installations, it
may be easier to adjust the front leg using the ³⁄₁₆" hex head
socket or adjustable wrench.
18
To raise the rear of the dishwasher, adjust the rear leveling leg
using a Phillips screwdriver. Turn clockwise until the dishwasher is
level front to rear.
Place level against top front opening of tub. Check that
dishwasher is level from side-to-side. If dishwasher is not level,
adjust front legs up or down until dishwasher is level. Close the
dishwasher door.

Connect to Water Supply

Copper tubing only: Slide nut, then ferrule, about 1" (2.5 cm)
onto copper tubing.