2-3.9 Power Off - SOYO SY-6VBA 133 User Manual

Hardware Installation
power. Keep holding down the <Insert> key until you see the message
of the CPU type and frequency shown on the screen.
4. Press the <Del> key during the system diagnostic checks to enter the
Award BIOS Setup program.
5. Select [SOYO COMBO SETUP] and move the cursor to the [CPU
Frequency] field to set the proper working frequency.
6. Select [Save & Exit SETUP] and press <Enter> to save the new
configuration to the CMOS memory, and continue the boot sequence.
Note: SOYO does not guarantee system stability if the user over
clocks the system. Any malfunctions due to over-clocking are not
covered by the warranty.

2-3.9 Power Off

There are two possible ways to turn off the system:
1. Use the Shutdown command in the Start Menu of Windows 95/98
to turn off your computer.
2. Press the mechanical power-button and hold down for over 4
seconds, to shutdown the computer. If you press the power-button for
less than 4 seconds, then your system will enter into Suspend Mode.
You are now ready to configure your system with the BIOS setup program.
Go to Chapter 3: BIOS SETUP
50
SY-6VBA 133