Other Features
Switching Between NTSC and PAL
The MVS-12 can switch to NTSC or PAL at startup.
fig.NTSC-PAL-boot.eps
NTSC
Switching to NTSC at Startup
At [MATRIX OUT], hold down [1] and turn on the power. This button flashes when the unit is switched to NTSC at startup.
* Once set to NTSC, the setting persists in memory even after power-off.
fig.NTSC-boot.eps
Switching to PAL at Startup
At [MATRIX OUT], hold down [2] and turn on the power. This button flashes when the unit is switched to PAL at startup.
* Once set to PAL, the setting persists in memory even after power-off.
fig.PAL-boot.eps
You can also use the menus to switch between NTSC and PAL. At the [SYSTEM SETTING] menu, for the [NTSC/PAL] item, select either [NTSC] or
[PAL]. After this operation, the setting requires few seconds to take effect.
PAL
29