Menu List When you press the [MENU] button, the menu appears on the monitor that’s connected to the VIDEO OUTPUT 4 connector of the XS-1HD. * The XS-1HD’s video output provides three screen modes: matrix, split, and switcher (p. 7). The menu that appears depends on the mode.
Menu List In Split Mode or Switcher Mode Menu item Value Explanation Specifies the output format. 720p, 1080i, 1080p, 1024 x 768, 1280 x 720, 1280 x 800, * In switcher mode, the output format of the VIDEO OUTPUT 4 Format 1366 x 768, 1280 x 1024, 1400 x 1050, 1600 x 1200, connector is fixed at 1080p/60 Hz.
Menu List Input Menu Menu item Value Explanation Indicates the video format that is being input to each VIDEO INPUT Input Status (Enter) connector, and the presence or absence of an HDCP signal. Input 1–4 (Enter) Displays a menu for making detailed settings for Input 1–4 (see below). Background Color (Enter) Displays the background color detailed settings menu (see below).
Menu List Composition Menu In Split Mode Menu item Value Explanation Displays the detailed settings menu for each layer (XPT 1–4) (see below). XPT 1–4 (Enter) XPT 1–4 detailed settings menu Menu item Value Explanation PinP Window Use the following items to adjust the layer. Adjusts the displayed position in the * The order in which layers are Position H...
Menu List In Switcher Mode Menu item Value Explanation Composition Use the following items to make composition settings (PinP, luminance key). Specifies whether to use composition or the AUX bus. PinP & Key: Composite the video using PinP/key. Use the XPT2 row of cross-point Mode PinP &...
If this is set to “Enable, ” the power automatically turns off when 240 minutes elapse with the XS-1HD in the following state. Auto Power Off Disabled, Enabled 5 The XS-1HD is not operated 5 Audio or video are not input 5 No output device is connected Remote Baudrate 9600, 38400 bps Specifies the communication speed (bps) of the REMOTE connector (RS-232).
Value Explanation The following items allow you to save the XS-1HD’s settings (the contents of memories 1–16) as a single file on a USB flash All Setting drive. A file saved on a USB flash drive can also be loaded into the XS-1HD.
This is the code by which the XS-1HD recognizes the end of the command. * stx (02H), ACK (06H), and Xon (11H)/Xoff (13H) are control codes. * When the external device transmits successive commands to the XS-1HD, it must wait for “ACK” to be returned before transmitting the next command.
0–127 Recall a memory stxMEM:a; a: 0 (Memory 1)–15 (Memory 16) Return version information stxVER; Obtain the status of the XS-1HD stxACS; Flow control Flow control XOFF (*1) The operation differs depending on the screen mode. (*2) Valid only when the screen mode is switcher mode.