Table of Contents
Advertisement
8.4 Main Error Messages and Their Remedies
Message
SET ORIGINAL TO ADF
REMOVE PAPER
×
TEXT/P
1.00
ä[A]ü#XXX:EMPTY
NO SUITABLE PAPER
(Flashing alternately)
LOAD PAPER (#XXX)
APS SIZE ERROR
AMS SIZE ERROR
PAPER SIZE ERROR
(Flashing alternately)
RESET PAPER (#XXX)
Di1811p
Cause
A document was not loaded into
the Document Feeder before
beginning a copy function (such
as, "2in1" copying or "Mixed Orig."
copying) that uses the Document
Feeder. Otherwise, the Document
Feeder is lifted up.
When interrupting a copy job to
perform a different copy operation
other than the "Book Separation"
function, the document for the
interrupted copy job was left in the
Document Feeder.
(While specifying Copy settings)
The selected paper tray has run
out of paper.
"#" indicates the paper tray, and
"XXX" indicates the paper size.
• While copying, the size of the
paper in the selected paper tray
has changed.
• While copying documents with
mixed sizes using the Auto
Paper function, paper of a
suitable size could not be
found.
"#" indicates the paper tray, and
"XXX" indicates the paper size.
While copying using the Auto
Paper function, paper of a suitable
size could not be found.
While copying using the Auto Size
function, the combination of the
document and paper sizes caused
the zoom ratio to exceed the range
×
×
between
0.5 and
2.0.
The paper loaded in the paper tray
caused a size error.
"#" indicates the paper tray, and
"XXX" indicates the paper size.
Remedy
Load a document into the Document
Feeder.
Securely close the Document
Feeder.
Remove the document from the
Document Feeder.
Either load paper of the specified
size into the specified paper tray, or
press the [Paper] key and select a
different paper size.
Either load paper of the specified
size, or press the [Paper] key and
select a different paper size.
Either load paper of a suitable size,
or press the [Paper] key and select a
different paper size.
Either load paper of a suitable size,
or use the
and
keys to
specify the zoom ratio.
• For a Paper Feed Unit, remove
the loaded paper, and then reload
the paper according to the
procedure described in "Loading
Paper" on page 3-4.
• For a custom paper size, refer to
"To copy onto label sheets" on
page 4-8.
• For the Manual Bypass, remove
the loaded paper, and then refer
to "To copy onto label sheets" on
page 4-8. For the Manual
Bypass, remove the loaded
paper, and then reload the paper
according to the procedure
described in "Copying Onto
Manually Fed Paper" on
page 5-16.
• For a custom paper size, refer to
"To copy onto postcards" on
page 4-14.
8
8-19
Advertisement
Table of Contents
