Boot Device Options Screen - Acer Altos 21000 Series User Manual

Boot Device Options
This option shows the target ID of the device you are booting from. The default
setting is 0 (zero). We recommend that you not change this setting. Some
operating systems will not run unless the boot device is set at zero.
The figure below shows the Boot Device Options screen.
Adaptec AIC-7896
Configuration
SCSI Bus Interface Definitions
Additional Options
Select SCSI peripherals from which to boot
To view peripherals by ID# select "SCSI Disk Utilities" from previous menu
Boot Channel...............................................................................
Boot SCSI........................................................................0
-----------Options Listed Below Have NO EFFECT if Multiple Lun Support is Disabled------------
Boot Lun Number ........................................................................ 0
Arrow keys to move cursor, <Enter> to select option, <Esc> to exit (
Figure 5-7 Boot Device Options Screen
Boot Channel
MultiChannel devices allow you to boot from either channel. Use this option to
identify the channel which should be scanned first during bootup. The default is
A First.
Boot SCSI ID
This option allows you to identify the SCSI device to be used as a boot device.
The range is 0 to 15; the default is 0.
Boot LUN Number
The AIC-7896 supports up to eight logical units. This option allows you to
identify the Logical Unit Number (LUN) to use during bootup. The default is 0.
The setting is valid only if BIOS Multiple LUN Support is enabled.
Altos 21000 Series User's Guide
AIC-7896 at Bus:Device 00:00h
Host Adapter SCSI ID................................ 7
SCSI Parity Checking ................................ Enabled
Host Adapter SCSI Termination................. Low ON/High ON
Boot Device Configuration
Boot Device Options .................................. Press <Enter>
SCSI Device Configuration ........................ Press <Enter>
Advanced Configuration Options ............... Press <Enter>
<F6> - Reset to Host Adapter Defaults
SCSISelect (TM)
-
Utility
A First
=default)
*