Ff. Delayed Ignition; Fan Does Not Shut Off When Door Is Open; Kk. Surface Burner Rings Turn Rainbow Colors; Ll. Riser Is Discolored Or Burned - Wolf Ranges Technical & Service Manual

Troubleshooting Guide
PROBLEM
FF. DELAYED IGNITION OF
OVEN BROILER
GG. RUSHING NOISE FROM
OVEN BROILER BURNER
HH. CONVECTION FAN DOES
NOT COME ON WHEN
SWITCH IS TURNED ON
II. CONVECTION FAN DOES
NOT SHUT OFF WHEN
DOOR IS OPEN
JJ. PROBLEMS ASSOCIATED
WITH THE OVEN LIGHT
KK. SURFACE BURNER RINGS
TURN RAINBOW COLORS
LL. RISER IS DISCOLORED OR
BURNED
POSSIBLE CAUSE
Igniter bracket bent
Defective glow coil igniter
Defective bi-metal valve
Bent orifice bracket holder
Blockage in venturi or orifice
Bent orifice bracket holder
Back Lighting situation
Oven broiler is on
Loose connection
Defective fan panel switch
Defective fan motor
Defective fan relay
No Power
Fan switch in "COOL" position
Defective fan door switch
Defective fan relay
Defective fan panel switch
Defective light bulb
Loose or disconnected wire connection in
the wiring circuit
Defective light panel switch
Defective light socket
No power
Discoloration from heat
Discoloration from heat, caused by flames
licking out from large pots at rear burners.
5-10
RANGES & & R R ANGETOPS
Straighten and position
Replace if not drawing 3.3 to 3.6 amps.
Replace if not drawing 3.03 to 3.3 VAC.
Straighten so that gas jet is aimed straight down
venturi tube, replace if necessary.
Clear as necessary
Straighten so that gas jet is aimed straight down
venturi tube, replace if necessary.
Gas is burning between screens or in box.
Broiler needs to be replaced
Fan does not function during broil
Check all components in circuit. See wiring dia-
gram.
Check for continuity and replace if defective
Check for continuity and replace if defective
Check for continuity and replace if defective
Check outlet and circuit breaker
This is normal operation. Instruct customer
Check for continuity and replace if defective
Check for continuity and replace if defective
Check for continuity and replace if defective
Check light bulb and replace if necessary
Check for voltage at the light sockets
Check light circuit with wiring diagram
Check continuity of the light socket
Check outlet and circuit breaker
This is normal after repeated use
This is normal. Always test cleaning solutions
on a non conspicuous stainless steel spot
before attempting to clean.
TEST / ACTION