Oven Flame Deflector; Oven Burner Tube; Oven Glow Coil Igniter - Wolf Ranges Technical & Service Manual

Component Access & Removal
RANGES & & R R ANGETOPS
Oven Flame Deflector Removal
The oven flame deflector sits on top of two deflector
rests, one at the front and one at the back of the oven
compartment. The screws that hold the front rest in
place pass through the unit frame into the rest and help
to secure the flame deflector.
Flame
Removing the flame deflector requires the lower access
Deflector
panel and the bottom oven panel to be removed first.
Then, loosen, but do not remove, the front burner rest
mounting screws and lift the deflector up and out of the
oven. (See Figure 3-32)
Back
Rest
Oven Burner Tube Removal
Front
The oven orifice protrudes into the burner tube inlet,
Rest
thus keeping the burner tube in the correct position at
the front. A screw at the back of the burner tube
Figure 3-32. Flame Deflector Removal
secures the tube to the bottom of the oven compart-
ment. The oven glow coil igniter is attached to a brack-
et on the side of the burner tube.
To remove an oven burner tube, the lower access panel
will need to be removed. Then, disconnect the oven
orifice fitting bracket from the bottom frame brace. Cut
any cable ties that may be around the glow coil wires.
Extract the screw at the back of the oven burner tube.
Lift the rear of the burner tube slightly while pulling it
towards the rear of the unit. Now, extract the glow coil
igniter mounting screws, pull the igniter away from the
Glow
burner tube, and lift the burner tube up and out of the
Coil
oven. (See Figure 3-33)
Igniter
Oven Glow Coil Igniter Removal
Two screws secure the oven glow coil igniter to a
bracket on the side of the oven burner tube. One of the
igniter wire leads is attached to the oven bi-metal valve
and the other wire lead is connected to another wire
Burner Tube
with a butt-connector.
To remove an oven glow coil igniter, the lower access
Figure 3-33. Burner Tube & Igniter Removal
panel will need to be removed. Then, cut any cable ties
that may be around the glow coil wires. Disconnect the
wire lead from the bi-metal valve and cut the other wire
lead just after the butt-connector. Now, lift the oven
burner tube out of the oven compartment with the glow
coil igniter attached. Extract the glow coil igniter mount-
ing screws and pull the igniter away from the burner
tube. (See Figure 3-33)
4-13