Oven Broiler Glow Coil Igniter; Oven Infrared Broiler Burner - Wolf Ranges Technical & Service Manual

Component Access & Removal
Oven Broiler Glow Coil Igniter Removal
The oven broiler glow coil igniter is attached to the ignit-
er bracket with screws and the bracket is attached to
the top of the oven compartment, just under the oven
broiler burner. The igniter wire leads are inserted
through a wire sleeve and then routed into a hole in the
side wall, then beneath the side panel and up to a
molex connector under the surface burners.
Begin removing a broiler glow coil igniter by accessing
the molex connector under the surface burners. With a
pin extractor, push the pins on the igniter wires out of
the molex connector.
NOTE: At this time it is recommended to tie a piece of
string or wire (about 24" in length) to the igniter wire
leads. By pulling this string down into the oven com-
partment with the wire leads during removal of the ignit-
er, the string can then be attached to the wires of the
replacement igniter and pulled back up to the molex
connector. Failure to use this string will require the unit
to be pulled from its installation and the side panel to be
removed.
Now, extract the igniter bracket mounting screws from
the top of the oven compartment and pull the igniter
wires down and out of the hole in the oven side wall.
(See Figure 3-34)
Oven Infrared Broiler Burner Removal
The broiler burner box sits in a pocket at the top of the
oven. The burner mixing tube runs from the burner box
to the back side of the appliance. The orifice holder
bracket is welded to the back end of the mixing tube.
The broiler burner is held in place by four brackets
placed over the edges of the burner box. The brackets
are then secured to the top of the oven with screws.
In order th remove the broiler burner, the unit must be
pulled from its installation and the back panel and flue
removed. Then, disconnect the gas line from the orifice
elbow and remove the orifice elbow from the holder.
Pull the broiler mixing tube out through the back side of
the unit. Inside the oven, disconnect the glow coil ignit-
er from the top of the oven. Extract the burner bracket
mounting screws.. Now, lower the broiler burner down
at the front slightly, then pull it forward, down and out of
the oven. See Figure 3-34)
NOTE: The mixing tube must be replaced with the
burner box. This is supplied as an assembly for serv-
ice. When inserting the mixing tube back into the burn-
er box, make sure that the tube is inserted fully to rests
against brackets inside the burner box.
RANGES & & R R ANGETOPS
Broiler Burner
Burner Mounting
Brackets
Glow Coil Igniter & Bracket
Figure 3-34. Broiler Burner & Igniter Removal
4-14