Table of Contents
Advertisement
EPSON Stylus PHOTO 895/785EPX/915/825
5.4 Firmware update
This section indicates the update procedures on the firmware in the memory card drive.
5.4.1 Firmware update method
1.
Enter the firmware data in the memory card.
Prepare the memory card in the FAT format.
C H E C K
Enter the firmware data to the top layer of memory.
P O I N T
2.
Turn the power of printer OFF.
3.
Insert the memory card to the printer, which has the firmware data.
4.
Turn the power of printer ON while pressing [←]+[↓]+[→] on the monochrome
screen.
5.
When writing data starts, the LED indication appears as follows. Release the
button.
Processing LED: Lights up.
6.
Processing LED shifts as follows.
Lights up → Goes off → Blinks
7.
When the processing LED blinks, it means writing is complete. Turn the power of
printer OFF.
8.
Wait for 10 seconds after turning the power of printer OFF.
C A U T I O N
When writing of firmware is complete, be sure to check the
firmware version. (Refer to the 5.4.2 "Firmware version check
method")
Adjustment
5.4.2 Firmware version check method
This section describes the check method of the firmware in the memory card drive.
1.
Turn the power ON while pressing the Print key, then print the detail
environmental setting values.
2.
Check the firmware version in the memory card drive. (Refer to the Figure 5-30.
"Print Example of Detail Setting Values")
Stylus PHOTO 895
EPSON Stylus Photo 895 STATUS SHEET (XXXXXXXX) (c) SEIKO EPSON CORPORATION
Figure 5-30. Print Example of Detail Setting Values
Firmware update
Revision B
Firmware version
133
Advertisement
Table of Contents
Troubleshooting
