Turning The Prestige On And Off; Load Default Ip; Switching The Key-Lock On And Off; Adjusting The Speaker Volume - ZyXEL Communications Prestige 2000W Quick Start Manual

Prestige 2000W Quick Start Guide
Call Use this key to make and receive calls.
Numerical Use these keys to enter numbers and characters.
Keypad
Hold down a key to automatically dial a predefined number (refer to Using Speed Dial Chapter
for more information).
2.1

Turning the Prestige On and Off

Press and hold the Off key for approximately 2 seconds to turn the Prestige on or off.
2.2

Load Default IP

While the Prestige is switched off:
1. Hold down Call key then press the Off key.
2. A message displays (below) indicating the Prestige has returned to the default IP address (see the Internet
Account Checklist in Required Information for the default IP address).
2.3

Switching the Key-lock On and Off

The keys lock automatically if the Prestige is in standby mode for more than one minute.
Press and hold the # key on the numerical keypad for approximately 2 seconds to lock or unlock the keypad.
2.4

Adjusting the Speaker Volume

Increase the volume during a call by pressing the right arrow key.
Decrease the volume during a call by pressing left arrow key.
This is the Prestige's speaker
volume, which displays during a call
if you use the left or right arrow keys.
2-2
Load Default IP
<<Release Key!>>
Figure 2-2 Load Default IP
12:00
12 ) ) ) ) ) ) ) ) ) )
123456
Figure 2-3 Speaker Volume
Keypad and Front Panel