Adjusting the Auto Brightness Sensor
When the Auto Brightness Sensor is activated, it
will automatically optimise the backlighting levels to suit
ambient light conditions�
1
From the Advanced Picture Settings menu, press
s to select Auto Brightness Sensor Settings ,
and then press
�
2
Press v or w to select On and press
Auto Brightness Sensor Settings
Auto Brightness Sensor
Backlight Adjustment Pro
3
Press s to select Backlight Adjustment Pro , and
then press
�
4
The Backlight Adjustment Pro window will appear�
Press
again to display the adjustment window�
5
Press v or w to select a point and press s or r to
adjust the level�
Backlight Adjustment Pro
Backlight Control Level
100
Control
Level
0
6
Press
to confirm the adjustment.
To cancel the adjustment when selecting a point, select
Cancel and press
To return the settings of all points to the factory
defaults, select Reset , and then press
Selecting LED Backlight Control
When LED Backlight Control is activated, it will
automatically optimise the backlighting levels for dark
scenes�
1
From the Advanced Picture Settings menu, press
s or r to select LED Backlight Control �
2
Press v or w to select High , Middle , Low or Off �
Note:
When Picture Mode is set to AutoView, Auto mode
is available.
Adjusting 3D Colour Management
You can adjust picture colour quality by selecting from 6
base colour adjustments : Red , Green , Blue , Yellow ,
Magenta and Cyan �
24
Using the TV's features (General)
�
On
48
Cancel
Reset
Ambient Light
�
�
1
From the Advanced Picture Settings menu, press
s or r to select 3D Colour Management , and
then press v or w to select On �
3D Colour Management
2
Press s or r to select Base Colour Adjustment �
3
Press
, and then press s or r to select the item
you want to adjust�
Base Colour Adjustment
Hue
Red
0
Green
0
Blue
0
0
Yellow
0
Magenta
Cyan
0
4
Press w , and then press s or r to select Hue ,
Saturation or Brightness �
Hue
Red
5
Press s or r to adjust the settings as required�
Note:
If you set 3D Colour Management to Off, Base
Colour Adjustment will not be available.
Resetting Base Colour Adjustment
The reset function returns base colour adjustment to the
factory settings�
1
From the Base Colour Adjustment menu, press
s or r to select Reset �
2
Press
�
Activating MPEG NR (Noise Reduction)
If the incoming MPEG signal exhibits noise (is grainy),
depending on the compression and conversion, the noise
may be reduced when using this function�
1
From the Advanced Picture Settings menu, press
s or r to select Noise Reduction , and then press
�
Noise Reduction
MPEG NR
DNR
2
Press v or w to select Off , Low , Middle or High �
On
Saturation
Brightness
0
0
0
0
0
0
0
0
0
0
0
0
Reset
Saturation
Brightness
0
0
0
Low
Auto