Programming Channels Into; The Tv's Channel Memory; Channel And Press Ok To View - Toshiba 47VL800A Owner's Manual

Programming channels into the
TV's channel memory
Auto Tuning
Auto Tuning will completely re-tune the TV and can be
used to update the channel list�
It is recommended that Auto Tuning is run periodically
to ensure that all new services are added� All current
channels and settings, e�g� favourites and locked channels,
will be lost�
Note:
As new services are broadcast, it will be necessary
to retune the TV in order to view them.
1
From the System Setup menu, press s or r to
select Auto Tuning �
System Setup
Menu Language
Auto Tuning
ATV Manual Tuning
DTV Manual Tuning
DTV Settings
Quick Setup
Location
Software Upgrade
2
Press OK �
A screen will appear warning that previous settings
will be deleted�
Auto Tuning
Previous settings will be lost! EXIT for no
change.
Tuning Mode
Bandwidth
3
Use v or w to select DTV and ATV , DTV or ATV �
Then, press s to select Start Scan and press OK to
continue with the Auto Tuning �
Press s to select Bandwidth , press v or w to select
7MHz, 8MHz or 7MHz and 8MHz ( - page 75)�
The TV will start to search for all available DTV and/
or ATV services�
You must allow the TV to complete the search. When the
search is complete, the Auto Tuning screen will display
the services found�
4
Use s or r to move through the list to select a
channel and press OK to view�
English
Auto
DTV and ATV
7MHz
Start Scan
Getting started
ATV Manual Tuning
Use the Manual Tuning operation if desired channels
cannot be preset by Auto Tuning or if you would like to
preset channels to specific position numbers one by one.
1
From the System Setup menu, press s or r to
select ATV Manual Tuning �
2
Press OK to display the ATV Manual Tuning menu�
Press r or s to select the position you want to set�
ATV Manual Tuning
Pos.
1
2
3
4
5
6
7
8
3
Press OK to display the settings menu� Press v or w
to select an item and press r or s to set the item as
shown below�
ATV Manual Tuning
Position
1
A
A. Position selection
B. System (Sound)
B/G , D/K , I or L
C. Colour System
A : Automatic, P : PAL , S : SECAM,
N4 : NTSC 4�43 (MHz), N3 : NTSC 3�58 (MHz)
If the colour of a certain channel is abnormal, the
automatic colour system selection (A) may have
malfunctioned or the sound system selection is
wrong� In this case, select another colour and/or
sound system�
D. Position skip selection
Press s or r to turn the position skip option
on " 8 " or off " ( "�The position will then be
skipped when you select channels with P U or P u �
The " 8 " mark will appear when you use the
Number buttons on the remote control�
E. Signal Class selection ( - page 77)
Press s or r to select C or S �
C: 2 ch - 12 ch, 21 ch - 69 ch
S: 1 ch - 41 ch, 51 ch - 55 ch
F. Channel selection
Press s or r until your desired channel is
displayed ( - page 77)�
- analogue -
Label
Channel
C2
C4
C5
C7
C9
C12
C23
C27
B/G A C 2 0
I
C E G
B D F H
17