Configuring The Antenna Input Source For The Ant/Cable Terminal; Programming Channels Into The Tv's Channel Memory; Programming Channels Automatically; Channel Program - Toshiba Regza 42RV535U Owner's Manual

52RV535U_EN.book Page 30 Tuesday, July 22, 2008 5:25 PM
Configuring the antenna input
source for the ANT/CABLE terminal
To configure the ANT/CABLE input:
1
Press Y and open the Setup menu.
2
Highlight Installation and press T.
Setup
Installation
REGZA LINK Setup
Sleep Timer
HDMI Settings
PC Settings
TOSHIBA Illumination
Power-On Mode Power-Saving
Demo Mode
Energy Saving Mode
3
(A new set of Installation menu icons will appear, as
shown below.) Open the Terrestrial menu, highlight
Input Configuration, and press T.
Installation
Terrestrial
4
Press C or c to select the input source (Cable or
Antenna) for the ANT/CABLE input on the TV.
Input Configuration
ANT/CABLE In
Cancel
5
To save your new settings, highlight Done and press
T. To revert to your original settings, highlight
Cancel and press T.
30
Chapter 5: Setting up your TV
On
Off
Home
Input Configuration

Channel Program

Channel Add/Delete

Channel Tuning Mode Auto
Signal Meter
Cable
Done
Programming channels into the
TV's channel memory
When you press < or , on the remote control or TV
control panel, your TV will stop only on the channels
you programmed into the TV's channel memory.
Follow the steps below to program channels into the
TV's channel memory.

Programming channels automatically

Your TV can automatically detect all active channels in
your area and store them in its memory. After the
channels are programmed automatically, you can
manually add or erase individual channels in the
channel memory.
Note:
• You must configure the ANT/CABLE input source before
programming channels (- left-hand column).
• If the ANT/CABLE input signal type is set to Cable, the
automatic channel programming process erases channels
that were previously programmed into the TV's memory.
• If the ANT/CABLE input signal type is set to Antenna, the
automatic channel programming process adds newly found
channels to the existing set of programmed channels (and
does NOT erase channels that were previously
programmed into the TV's memory.) To remove an Antenna
source channel from the memory, you must manually delete
it.
• To tune the TV to a channel not programmed in the channel
memory, you must use the Channel Number buttons on the
remote control.
• Programming channels when the ANT/CABLE input is
configured for Cable will take substantially longer than when
the antenna input is configured for Antenna. This is normal;
however, once channel programming is finished, you should
not have to repeat the programming process again unless
your Cable TV service lineup changes significantly.
To program channels automatically:
1
Configure the ANT/CABLE input, if you have not
already done so ( - left-hand column).
2
From the Setup menu, highlight Installation and
press T. A new set of Installation menu icons will
appear.
RV535U (E/F) Web 213:276