Turning The Tv On; Switching On The Tv; Switching Off The Tv; Tuning The Tv For The First Time - Toshiba 47VL800A Owner's Manual

Turning the TV on

Switching on the TV

Connect the power cord to a wall outlet� The ! power
indicator light should be red (standby mode)�
1
Press 1 on the remote control or ! on the TV front
panel� The ! power indicator lights in Blue�
Note:
If you watch black and white programmes when the
Colour System mode is set to Auto, colour noise
may appear on the screen. In this case select the
appropriate Colour System (

Switching off the TV

1
Press 1 on the remote control or ! on the TV front
panel to switch to the standby mode�
Notes:
• The TV is not fully disconnected from the main
supply, as minute current is consumed even when
! is turned off. When the TV will not be used for
a long period of time, such as during vacation or
travel, remove the power plug from the wall outlet.
• If power is cut off while you are viewing the TV,
the Last Mode Memory function turns on the TV
automatically when power is applied again. If
power is going to be off for a long time and you are
going to be away from your TV, unplug the power
cord to prevent the TV from turning on in your
absence.

Tuning the TV for the first time

Before switching on the TV, put your decoder and media
recorder to standby, if they are connected, and ensure that
the aerial is connected� To setup the TV, use the buttons on
the remote control as detailed on page 11�
1
Press the 1 button� The Menu Language screen
will appear. This screen will appear the first time that
the TV is switched on and each time " Reset TV " ( -
page 36) is executed�
Menu Language
2
Press v or w to select the menu language English or
Français �
3
Press OK , to display the Primary/Secondary
Language and Primary/Secondary Audio
Language item� Press s , r , v or w to set the
selectings as desired�
page 17).
-
English
Getting started
4
Press OK , to display the Time Zone menu and press
v or w to select the item you want to set� (New
South Wales, Northern Territory, Queensland, South
Australia, Tasmania, Victoria, Western Australia or
Australian Capital Territory)
5
Press OK , to display the Location menu ( - page
19)�
Press v or w to select Home or Store � For normal
home use, select Home �
Location
To use the TV for displaying in a store showroom, please
select [Store]. [Home] mode is recommended for normal
use.
Store mode:
• A confirmation menu will appear.
• AutoView menu is not available�
6
Press OK , to display the TV Mounting menu, press
v or w to select Stand or Wall �
TV Mounting
If you are mounting the TV on a wall please select [Wall].
[Stand] is recommended for other uses.This setting may be
modified later under Sound Navigation in the SOUND menu.
7
Press OK , to display the AutoView menu
( - page 23)�
Press v or w to select Yes or No �
AutoView
AutoView mode automatically adjusts picture settings to
suit ambient light conditions.
Do you wish to enable AutoView mode?
8
Press OK to display the Auto Tuning startup screen�
Use v or w to select DTV and ATV , DTV or ATV �
Press s to select Bandwidth , press v or w to select
7MHz , 8MHz or 7MHz and 8MHz ( - page 75)�
Then, press s to select Start Scan and press OK �
You must allow the TV to complete the search.
Auto Tuning
DTV Tune
ATV Tune
When the search is complete, the TV will
automatically select position one�
The Auto Tuning results screen will display the
services that are found�
Home
Stand
No
Progress
3%
Waiting...
Channel: 10
Found
2
13