Paper Requirements - Canon FAX-L160 Reference Manual

Before Using the
Machine 1
Document and Paper
2
Sending and
Receiving 3
Copying
4
Printing (FAX-L160
Only)
5
System Manager Cannot receive a document manually.
Settings 6
Maintenance
7
Troubleshooting
8
Appendix
9
Table of Contents
Index
Q Is paper loaded in the machine?
A Make sure paper is loaded in the machine. (See "Set
Up the Machine, " in the Starter Guide.)
Q Can the sender's machine send the CNG signal,
which tells your machine that the incoming call is
a fax call?
A Some machines cannot send this signal. In such cases,
receive the fax manually.
Is the machine set to receive manually?
Q
A For the machine to receive faxes manually, the receive
mode must be set to <Manual>. (See "Basic Receiving
Method, " on p. 3-23.)
Q Did you hang up the optional handset or the
external telephone before pressing [Start] or
dialing the remote reception ID?
A Always press [Start] or dial the remote reception ID
before hanging up. Otherwise you will disconnect the
call.
Back
Q Are documents set on the ADF?
A After removing the document from the ADF, please
attempt manual receiving again. If you press [Start]
when documents are set on the ADF, it automatically
switches to manual sending.
Print quality is poor.
Q Is the toner low or unevenly distributed?
A Redistribute the toner inside the toner cartridge. If
the problem persists, replace the toner cartridge. (See
"Replacing the Toner Cartridge, " on p. 7-8.)
Q Is the correct type of paper loaded in the machine?
A Make sure you load paper that meets the
requirements for use. (See "Paper Requirements, " on
p. 2-5.)
Q Is the sender's machine functioning properly?
A Ask the sender to check that the scanning
components of the machine are clean.
TOP
Previous Next
8-26