Golden Blount EL GRANDE HD5030-TV Installation And Operating Instructions Manual page 8

Model HD5030-TV is supplied with the component parts for outside combustion with the exception
of the 4" flex duct. It is recommended that the outside air system be used whenever possible.
Connect 4" Class-1 Flex duct or Metal Vent to duct collar on both sides of firebox; run ducts to
fresh air source and terminate using duct termination caps. The outside air can be opened by
pushing control knobs toward back of fireplace and closed by pulling towards front (Refer to
figure 8.1).
OUTER
CASING
DUCT
COLLAR
ONE ON LEFT SIDE &
ONE ON RIGHT SIDE
Figure 8.1
Consult local building codes before gas line installation. This gas fireplace is designed
to accept a 1/2" male flare fitting attached to a 1/2" supply line. Have the gas line in-
stalled by a qualified service person in accordance with all building codes. Install gas
line to fireplace on the right side attaching gas line to the gas flex line inside the control
box accessed by opening the control box door.
Finishing the Wall
Finish the wall with the material
of your choice. Do not install a
combustible mantle or other
combustible projection above the
fireplace opening unless it is a
minimum of 12 inches above top
of fireplace opening. (Figure 8.2)
Caution: All joints between the finished wall and the fireplace surround (Top and Sides)
can only be sealed with non-combustible material. Only non-combustible material can
be applied as facing to the fireplace surround. (Figure 8.2)
A Hearth Extension may be installed. But it is not required for vented gas fireplaces.
Installing Outside Air Kit
DUCT
TERMINATION
CAULKING
WALL
Connecting the Gas Line
MANTLE
12" MIN
TOP OF
OPENING
Figure 8.2
Hearth Extension
8
RAIN CAP
CONTROL
KNOB
STUD
2X4
HEADER
FINISHED
WALL
NON-COMBUSTIBLE
SEAL JOINT
ONE ON LEFT SIDE &
ONE ON RIGHT SIDE