Dimension - Vision VN7XFHD Instruction Manual

If there are problems in operating, please refer to the checklist below. If the problem persists, please
contact the agent where this product is purchased.
Problems
Nothing appears on the screen.
The image on the screen is dim.
The image on the screen is dark.
The camera is not working
properly, and the surface
of the camera is hot.
Color is not correct.
The screen flickers continually.
RS-485
communication fails.
8. Dimension(mm)
Troubleshooting
 Please check that the power cord and line connection
between the camera and the monitor are fixed properly.
 Please check that you have properly connected VIDEO
cable to the VIDEO output jack of the camera.
 Is lens stained with dirt? Clean your lens with soft, clean cloth.
 Set the monitor to proper condition.
 If the camera is exposed to too strong light, change
the camera position.
 Adjust the contrast feature of the monitor.
 If you have an interim device, set the 75Ω / Hi-z properly.
 Please check that you have properly connected the camera
to an appropriate power source.
 Please check the setting of AWB menu .
 Please check that direction of camera turns toward the Sun.
 Please check the polarity between RS-485 Control Port
and RS-485 cable.
485 Control Board Connection Port
(+)CONNECTION TERMINAL(TRX+)
(-)CONNECTION TERMINAL(TRX-)
 Please check the RS-485 Communication establishment
initial value.
*RS-485 Communication establishment initial value
Item Camera ID
Initial value 001

We recommend that you make ground connect
between camera and controller in order to maintain
safety communication control.
18
RS-485 Control Port
485+
485-
BAUD RATE UART MODE
9600 8-NONE-1
RET PKT
ENABLE