Table of Contents
Advertisement
Troubleshooting
44
Ice and water system (all models)
Problem
Ice maker is
not producing
enough ice or ice is
malformed.
Ice forms in inlet
tube to ice maker.
Refrigerator is
leaking water.
Possible causes
Ice maker has just been
installed or a large amount
of ice has been used.
Water pressure is too low.
Water filter (if fitted)
is clogged or needs to
be changed.
Water pressure is too low.
Saddle valve not open
completely.
Freezer temperature is
too warm.
Plastic tubing was used to
complete water connection.
Improper water valve
was installed.
What to do
Wait 24 hours for ice production to begin or
for ice maker to restock after emptied.
Low water pressure can cause valve to leak.
Water pressure must be between 35 to 100
pounds per square inch to function properly.
A minimum pressure of 35 pounds per
square inch is recommended for refrigerators
with water filters.
Change water filter (see page 29).
Water pressure must be between 35 to 100
pounds per square inch to function properly.
A minimum pressure of 35 pounds per
square inch is recommended for refrigerators
with water filters.
Open saddle valve completely.
See pages 11 or 16 to adjust controls. Freezer
temperature should be around -18˚C.
It is recommended copper tubing is used
for installation. Plastic is less durable and
can cause leakages. The manufac turer is not
responsible for property damage due to
improper installation or faulty/leaky water
connection.
See 'Connecting the water supply' , page 9.
Self-piercing and 4.7 mm saddle valves
cause low water pressure and may clog
the line over time. The manufacturer is not
responsible for property damage due to
improper installation or water connection.
Advertisement
Table of Contents
