Table of Contents
Advertisement
Troubleshooting
42
Ice and water (RX693 / RX594 models only)
Problem
No indicator lights
are lit on display.
Ice or water are not
dispensed when
pads are pressed.
Possible causes
Freezer door is not closed.
Refrigerator is not
plugged in.
Fuse is blown, or circuit
breaker needs to be reset.
Power outage has occurred. Call local power company listing to report
Refrigerator is in
Sabbath mode.
Freezer door is not closed.
Controls are locked.
Water tank is filling.
Ice bin not installed
properly.
Ice maker has just been
installed or a large amount
of ice has been used.
Water pressure is too low.
Water filter (if fitted)
is clogged or needs to
be changed.
What to do
Verify that freezer door is closed. Power is
removed from the control when freezer door
is opened.
Plug in refrigerator.
Replace any blown fuses.
Check circuit breakers for any tripped
circuits.
outage.
See 'Sabbath mode' , see page 14.
Verify that freezer door is closed. Power is
removed from the control when freezer door
is opened.
See 'Display and Dispenser Lock' , page 25.
At initial use, there is an approximate
1 – 2 minute delay in dispensing while the
internal water tank is filling.
Reinstall ice bin (see page 26).
Wait 24 hours for ice production to begin or
for ice maker to restock after emptied.
Water pressure must be between 35 to 100
pounds per square inch to function properly.
A minimum pressure of 35 pounds per
square inch is recommended for refrigerators
with water filters.
Change water filter (see page 29).
Advertisement
Table of Contents
