Table of Contents
Advertisement
Designation Sheet 1 Tray / Designation Sheet 2 Tray
You can specify and display the paper tray that is used for setting designation sheets.
You can also specify the display timing and copy method for two-sided copying.
The default setting is Off.
When [At Mode Selected] is selected, slip sheet tray settings only appear when the cover function or
slip sheet function is selected.
When [Full Time] is selected, the slip sheet tray is always displayed.
Separation Sheet Tray
You can specify and display the paper tray that is used for setting separation sheets.
You can also specify the display timing and copy method for two-sided copying.
The default setting is Off.
When [At Mode Selected] is selected, separation sheet tray settings only appear when the cover
function or slip sheet function is selected.
When [Full Time] is selected, the slip sheet tray is always displayed.
Paper Type Detect
You can specify whether or not the machine automatically detects the paper type (plain 1, plain 2,
thin, middle thick, thick 1, thick 2, thick 3, translucent paper, or OHP transparency). If detection is
enabled and the paper type that is loaded differs from the detected paper type, a warning message
appears. Press the [Clear/Stop] key, remove paper from inside the machine and configure new paper
settings correctly or change paper.
• On
• Off
Trays that can be specified:
• Bypass Tray
• Tray 1
• Tray 2
• Tray 3
• LCT
• Some paper types cannot be detected.
• Depending on the paper type, the machine reports a warning message even though a proper
paper type is loaded. In this case, specify "Off" for this setting.
• If you select duplex copying, the paper type of the backs of originals cannot be detected.
• [Paper Type Detect] works only if you select "No Display", "Recycled Paper", "Translucent
Paper", or "OHP" in [Paper Type:] in System Settings.
Tray Paper Settings
2
51
Advertisement
Table of Contents
