Table of Contents
Advertisement
Caution: Before inserting the Battery Pack into the Miter Saw, be certain that the Trigger
Switch is in the Off position. Otherwise, the Saw Blade will start turning immediately,
creating an unsafe condition.
1.
Insert Battery (40) into the receptacle at the back of the Miter Saw.
2.
Secure the Lock-spring Clasps to each side of the receptacle. See photos below.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other
construction activities, contain chemicals known [to the State of California] to cause
cancer, birth defects or other reproductive harm. Some examples of these chemicals
are:
•
Lead from lead-based paints
•
Crystalline silica from bricks and cement or other masonry products
•
Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals: work in a well ventilated area, and
work with approved safety equipment, such as those dust masks that are specially
designed to filter out microscopic particles. (California Health & Safety Code 25249.5,
et seq. )
Table Lock
Screws (52)
Auxiliary Wood Fence
To help avoid small, short cut pieces of stock from being caught by the blade or shot off, it
is recommended to mount an auxiliary wood fence (not supplied) to the saw's metal Fence
(55).
1.
Cut a 1/2 inch thick piece of wood to match the height and length of the metal Fence.
SKU 02811
2811.p65
6
Inserting Battery into Unit
Operation
Switch Button (44)
Bevel Angle
Screw (1)
Page 6
Lock Button (37)
Arm Release
Knob (17)
10/10/03, 9:59 AM
Lock-spring
Clasps
Battery (40)
Advertisement
Table of Contents
