Table of Contents
Advertisement
Battery (#14)
Guard (#9)
Exhaust Hole
Movable
Guard (#8)
Base (#50)
Nut Bold (#1)
Washer (#2)
Adjusting The Saw Prior to Cutting
1.
To adjust the angle of blade up to 50°, loosen knob (#57) and move base plate (#50)
down, observing the degrees indicated on the angle plate (#53). Tighten knob (#57).
See illustration on next page.
2.
To adjust the depth of the cut, loosen knob (#43, not visible) located behind motor
housing, and move base plate (#50) down while observing the amount of saw blade
exposed under base plate. Tight knob (#43).
Prepare Material Before Cutting
1.
Support large panels to minimize risk of blade pinching and saw kickback.
2.
Use a rip fence or secured straight edge guide when ripping material.
3.
Securely clamp material to be cut to work bench.
4.
Make sure saw does not cut into supports or workbench.
5.
Use the appropriate type of blade for the material you are cutting.
Note: Always switch to a fresh battery when tool performance begins to diminish. Se-
vere heat is most destructive to a battery; the more heat generated, the faster the battery loses
power. A battery that gets too hot can be permanently damaged. Never over-discharge a
battery by using the tool even after tool performance is decreasing. Never attempt to dis-
charge a tool's battery by continuing to pull the tool trigger. When tool performance begins
to diminish, stop the tool, re-charge the battery and use the fresh battery for optimal
performance.
SKU 37412
Knob (#43, not visible)
Safe Button (#45)
Page 6
Switch Button (#47)
Stop Button (#17, not visible)
Hex Key (#48)
Angle Plate (#53)
Knob (#57)
Hide quick links:
Advertisement
Table of Contents
