Before Installation; Installation Diagram - GReddy e-01 Instruction Manual

Before Installation

• Make sure the engine has cooled down before working under
the hood.
• Take the key out of the ignition switch and disconnect the
negative terminal of the battery.
• Before mounting the Valve unit and the Pressure sensor,
be sure the supplied vacuum hose is long enough to reach
them.
• Locate the actuator/wastegate, factory boost controlling
solenoid valve, and fuel pressure regulator or true vacuum
source before installation.

Installation Diagram

Display unit Display unit
Center unit Center unit
Pressure sensor Pressure sensor
Engine Engine
Fuel regulator Fuel regulator
Intercooler Intercooler
Controller Controller
Option (yellow)
RPM (brown)
Ground (black)
Power 12V (red)
Turbo Turbo
Actuator Actuator
Air cleaner Air cleaner
Valve unit Valve unit
6