Set Boost - GReddy e-01 Instruction Manual

A-1 SET BOOST

SET BOOST

Boost setting
2. AUTO/MANUAL & SET boost
AUTO - - - Auto learning mode. This feature will automatically
program the e-01 for best boost response and consistant boost curve.
See next page for the learning procedure. Select this mode and input
the desired boost setting.
MANUAL - - - Manual input mode. This feature will allow the user to
input a boost setting for a custom boost curve. This feature requires
the user to input boost controller solenoid duty cycle value and monitor
the boost in display mode to see how much boost is increased at the
inputted duty cycle. 0% will be same as base boost or boost controller
turned OFF. 100% will be same as disconnecting the wastegate signal line.
Select this mode and input the desired solenoid duty cycle.
• To use the boost controller right away, select the AUTO mode
and follow the learning procedure.
• If you select the MANUAL mode, input the SET, GAIN, START
BOOST setting to achieve the similar boost control as using
AUTO mode.
3. START BOOST
This feature is used to improve the turbo spool up by holding the signal
to the wastegate which holds the wastegate completely closed until
the boost reaches the Start Boost value. If the value is too close to the
SET Boost value, the boost will over shoot (boost spike).
Set this feature 20kPa (0.2kg/cm2, 2.8psi) less that the SET boost value.
4. GAIN
This feature is used to stabilize the boost by changing the control
valve's duty cycle. The larger the value, the faster the response will be
and the lower it is, the response will be slower. If the value is set too
high, the boost will overshoot (boost spike).
Select this mode and input the desired solenoid duty cycle.
Set the boost controller
features.
1. BOOST SELECT
Select from 3 settings
Hi High boost mode
Lo Low boost mode
OFF Stock boost mode
18