Pressure Sensor Installation - GReddy e-01 Instruction Manual

Installation Diagram

Pressure Sensor Installation

Orifice
(1) Mount the Pressure sensor to the body near the fuel regulator
using the supplied bracket and bolt.
(2) Cut the vacuum line on the fuel regulator and install the
supplied three way-fitting.
(3) Place the supplied orifice to the side that will connect the
sensor and connect the 4ø Hose from the three way fitting to
the sensor.
• Make sure that the Sensor connector is pointed down as
shown in the diagram above.
• Make sure that the sensor is securely mounted on the body.
• Avoid mounting the sensor in the hot area or where it can get wet.
• Toyota's JZ engines and Mitsubishi's 4G63 engine have
fuel pressure controlling solenoid valves. For these vehicles,
make sure to get pressure from the line between the intake
manifold and the solenoid.
• Make sure to secure the 4ø Hose with zip ties.
9
Fuel pressure regulator
Connector must
Point Down
Intake Manifold
Important!