Changing Setting In Display Mode; Peak Hold Reset; Lock Feature - GReddy e-01 Instruction Manual

C DISPLAY

Changing Setting in display mode

HI, LO boost selection, SET BOOST , GAIN, START BOOST can
be adjusted in any of the Digital, Graph, Gauge, and Bar graph
display mode.
Press the SET knob to move the cursor to the target setting.
Turn the SET knob to make changes.
Press the SET knob again to confirm the setting.
* Press the MENU button to cancel at any time.

PEAK HOLD Reset

To clear the stored Peak Hold data, hold down the up button on the
4-way navigation button for 2 seconds.

LOCK Feature

This feature is used to lock all the settings to prevent any problems.
To lock, press down the MENU button and SHIFT button for 5
seconds.
Repeat the same procedure to unlock.
Lock feature can only be set in the Display mode.
When the unit is locked, the message shown is displayed and the
"LOCK" will appear in the upper right hand corner of the title bar.
Pres the SET knob
HI / LO
Pres the SET knob
SET
Pres the SET knob
GAIN
Pres the SET knob
START BOOST
Pres the SET knob
Cursor will disapear
PEAK
34