Parameter - GReddy e-01 Instruction Manual

D-1 PARAMETER
This window allows you to change Airflow Meters, Injectors, set the
Throttle, and select which map to use.
2. AIRFLOW CHANGE
• When the Airflow meter or MAP sensor is upgraded, check the
Sensor Type from the "Vehicle Specific ECU wire location chart", and
select it from the pull down menu.
• The Airflow Type programmed with the Main unit's rotary switch
will display as "Main Unit Setting" in the pull down menu.
• When the airflow meter is upgraded, the airflow signal value will
change. Make sure to check Air/Fuel Ratio with a proper
equipment to ensure proper fuel mixture.
3. Injector Change
• When upgrading the injectors, this feature calculates the difference
of the two sizes and trims the whole fuel map (factory map) for
proper idling and drivability.
• Input the factory injector size and the upgrade injector size.
• This system can control up to 150% larger injectors than the
factory. Too large of an injectors can cause problems performing
properly.
• When the injectors are upgraded, the injector signal value is being
altered. Make sure to check the Air/Fuel Ratio with a proper
equipment to ensure proper fuel mixture.
43
1. GReddy PR.SENSOR
Choose this box when an
optional GReddy pressure
sensor will be used for the
scale of each Map tables.
• This function is used when
the system exceeds the Air
Flow Meter's capacity. The
factory ECU will continue to
read off the Air Flow Meter,
but the e-Manage system
will work off the GReddy
pressure sensor.
Important!