E-Manage; Initial Set Up Linking With The E-Manage; Features; Optional Parts - GReddy e-01 Instruction Manual

D e-manage
Use this feature to tune the e-manage unit by linking with a USB
Cable (standard A-B USB available at any computer supply retailer).

Initial set up linking with the e-manage

1. Update the e-manage unit – This will start automatically when links
with the e-manage)
See page 31 B-11 PROGRAM
2. Import program from e-manage
See page 52 D-9 IMPORT/EXPORT
3. Set the Parameter
See page 43 D-1 PARAMETER

Features:

• Air Flow Adjustment Map
This 16 x16 (rpm x throttle position) table is used to fine-tune the
input signal of the Air Flow Meter or MAP Sensor to the ECU for
fuel enrichment.
• Upgrade Injectors
Controls upgrade injectors. (up to 150% larger than factory)
• Upgrade Airflow meters
Controls upgrade Airflow meters.
• Boost limiter cut feature
Eliminates factory boost limiter.
• Anti Engine Stall feature
This is used to stabilize the rough idle due to turbo compressor surge,
Blow-off valve vented out to the atmosphere or use of a high lift camshaft.
• VTEC® Setting
This is used to set the VTEC setting without going in to the Main Unit.
• Map Trace feature
This allows the tuner to pin point the current location on any map table.
• Security Setting feature
This allows the tuner set up a password to apply a security lock to
the data in the main unit.

Optional Parts:

• Harness Kit (Injector control)
This harness is used when controlling main injectors or sub
injectors
• Harness Kit (Ignition Timing Control)
This Harness is used when controlling the ignition timing.
• GReddy Pressure Sensor
GReddy pressure sensor can be used for the scale of each Map
table. This is used when the factory system exceeds the Air Flow
Meter or MAP sensor capacity.
40