Learning Procedure (Only For Auto Mode) - GReddy e-01 Instruction Manual

A-1 SET BOOST

Learning Procedure (only for AUTO mode)

This step will program the correction value necessary
to achieve the desired boost setting.
(1) Select AUTO mode and input the target boost
value. AUTO.P will indicate phase 1 in the upper
right corner of the display.
(2) Make a full throttle run in 3rd or 4th gear to go into
boost. It will run stock boost to confirm the base
boost. Then it will gradually go up the the target
boost value. As soon as the boost nears the target
boost value, release the accelerator.
• If the vehicle's stock boost is not stable (not
holding consistant boost pressure), it is possible
that this feature would not be able to confirm the
base boost. In this case, use the MANUAL mode.
(3) Once the target boost value is confirmed, the
AUTO.P will start to flash indicating phase 2.
(4) Make another full throttle run in 3rd or 4th gear to
go in to boost. As soon as the boost reach
consistant target boost, release the accelerator.
(5) Once it confirms consistant target boost, AUTO.P
will turn off. This completes the learning
procedure.
• Always perform the learning procedure at full throttle.
• It is possible that AUTO mode might not program properly due to
turbocharger size, wastegate's capacity and extreme exhaust
pressure.
• Each SET boost setting will initially require learning.
• Relearning is required when the GAIN setting is changed. This
will set the unit to phase 1 mode with AUTO.P lit.
• If the Boost select setting (HI/LO) is changed or ignition is turned
off during phase 2 (AUTO.P Flashing), it will return to phase 1
19
Important!