Detaching The Rower Belt - First Degree Fitness Viking 2 AR Owner's Manual

Detaching the Rower Belt:

1. To detach belt, simply pull beyond the range of the normal rowing stroke until the belt
detaches from the belt bungee pulley.
Tip: You'll hear the Velcro separating just before the belt detaches.
Inner Clip
Bungee Hook End Frame
Reattaching the Rower Belt:
1. Begin reattaching the Rower Belt by threading around the Rower Belt Pulley with the Velcro side
facing upward as illustrated.
2. Next, thread the Belt around the Idle Wheel as shown. Once around the Idle Wheel, attach the Rower
Belt to the Belt/Bungee Pulley. There is an obvious "lip" at the attachment point.
17
2. Unhook the Bungee Shock Cord from the Rear Leg.
Then, push out the Inner Clip from the Bungee Hook End
Frame. Pull the Bungee through the Inner Clip until free.
This will allow for the Bungee Shock Cord to be threaded
completely out of the Main Frame and up to the Belt
Bungee Pulley where it will be re-attached once the
Rower Belt is in the proper position.
Idle Wheel