Replacing The Rower Bungee Shock Cord - First Degree Fitness Fluid INNOVATION E316A User Manual

Replacing the Rower Bungee Shock Cord

1. Remove the Perspex Cover from
rear of upper frame.
Disconnect sensor lead before
removing cover completely.
2. Move the Rowing Handle from the
S-Bend to a point where it is resting
on top of the Tank. This helps line up
the Bungee Cord hole for easier
removal/replacement. Detach Bungee
Cord from lower rear attachment
point.
3. Unwrap the Bungee Cord from all of
the Bungee Pulleys.
4. Next, remove the Magnetic Ring. To loosen
the Rear Main Shaft Bolt holding the
Magnetic Ring in place, it is necessary to
keep the Main Shaft and impeller assembly
from turning with the Bolt. Open the Yellow
Tank Plug, and insert a wrench wrapped in a
lint free cloth (to protect the electroplating
finish on the blades) to catch the impeller
blade and allow the Rear Main Shaft Bolt to
be loosened as shown below right with a
6mm Allen key.
Caution: Do not allow a dissimilar metal to
directly contact the impeller blade.
Premature rusting could occur. Cover any
tool inserted the Tanks with a lint free
cloth and keep Ringers clear.
WARNING ： Do not insert Ringers into Tank!
Rear Main
Shaft Bolt
and Magnetic
Ring
23