Table of Contents
Advertisement
Tank Belt Adjustment
1. Remove large metal inspection plate.
3. Loosen both the rear and front tank
bolts slightly as shown left. Remove
front
Rubber Belt Cover.
2. Using a long tool, push out the rear
end cap as pictured below left. This
will give you access to the tank
tensioning bolt (shown lower right).
End Cap
4. Using a 6mm Allen Key, tighten the
Belt using the Tank Tensioning Bolt
until the belt no longer slips during
hard rowing.
Note: Do not over tighten tank bolts.
Tip: Twist the Belt by hand to gauge
tightness. Correct tension should be
obtained when no longer able to twist
more than 60 degrees
29
Advertisement
Table of Contents
