Ash Disposal; Ash Removal - Bosca SPIRIT 500 Installation And Operating Instructions Manual

OWNER´S MANUAL

ASH DISPOSAL

Ash should be placed in a metal container with a tight-fitting lid. The closed container or ashes should
be placed on a noncombustible surface or on the ground, well away from all combustible materials
pending final disposal. If ashes are disposed of by soil burial or otherwise locally dispersed, they should
be retained in the closed container until all cinders have thoroughly cooled.

ASH REMOVAL

Remove ashes periodically as they fill the firebox. To remove ashes:
• Make sure fire is out and firebox is cool.
• Clean heat exchanger tubes (see "CLEANING" and Figure 17)
• Remove the burnpots inner sections by grasping it and pulling straight up
• Empty ashes from the inner section and scrape with cleaning tool;
Make sure holes are not plugged.
• Vacuum to remove ashes from the burn chamber interior and the
burnpot shell. Or sweep ash with small broom into ash cleanout drawer.
WARNING: Make sure ashes are cool to the touch before using a
• Dispose of ashes properly (See "ASH DISPOSAL" above).
• Replace inner section into burnpot; make sure it is level and pushed all the way back
down and that the igniter hole is to the rear when it is reinstalled (see Figures
19 a,19 b,19 c ).
• Check gasket condition on air intake tube.
• Make sure the burnpot is level and pushed all the way in, if the collar on the burnpot
attached to the fresh air tube is not pushed back to meet the firebox wall, the Hot
Rod will not work properly.
(See "VACUUM USE".)
-26-