Operation; Panel Controls - Bosca SPIRIT 500 Installation And Operating Instructions Manual

OWNER´S MANUAL

OPERATION

PANEL CONTROLS

The blowers and automatic fuel supply are controlled from
a panel on the top left-hand side of the stove.
The control panel functions are as follows:
ON/OFF SWITCH
When pushed, the stove will automatically ignite. No
other firestarter is necessary. The igniter will stay on
for at least 10 and up to 15 minutes, depending on when
Proof of Fire is reached. The fire should start in about 5
minutes.
The green light located above the On/Off button
(in the On/Off box) will flash during the ignition start-up
period.(see figure 11 )
The Feed Rate Advance is inoperable during the ignition
start period. When the red light continuously stays on, the
Feed Rate Advance can be adjusted to achieve
the desired heat output.
NOTE: If the stove has been shut off, and you want to re-start
it while it is still warm, the "On/Off" button must be
held down for 2 seconds.
FUEL FEED SWITCH
When the "Fuel Feed" button is pushed and held down
the stove will feed pellets continuously into the burnpot..
While the stove's auger system is feeding pellets the amber
light (in the "Fuel Feed" box") will be on. (See figure 12 )
Amber Light On
fig. Nº12
T-STAT
MANUAL
AUTO
AUGER
TRIM
MAX
4
3
2
FAN
1
MIN
AUGER
HEAT
ON/OFF
LEVEL
T-STAT
AUTO
MANUAL
AUGER
TRIM
MAX
4
3
2
FAN
1
MIN
AUGER
HEAT
ON/OFF
LEVEL
fig. Nº11
-17-