Bosca SPIRIT 500 Installation And Operating Instructions Manual page 15

OWNER´S MANUAL
• Attach the L-Vent adapter, a section of pipe and clean out tee, making sure the clean out
tee is centered in the chimney flue area. Use RTV, metallic tape, and a minimum of three self-taping
screws at all joint connections to ensure a tight seal.
• Install and seal the top plate from step 3 with non-hardening mastic. Slip the storm
collar over the pipe, and while holding the pipe at the proper elevation, affix the
collar with a minimum of three 1/4" stainless steel sheet metal screws. Seal all joints
and seams around the collar.
• Connect the horizontal pipe by pushing it through the hole in the masonry and lining
it up with the branch in the tee. Push the pipe into the tee while twisting it to lock it
into the tee.
• If desired, once the horizontal pipe is in place, the space between the pipe and
masonry may be filled with high-temperature grout.
• Install the trim collar. An adjustable pipe length and adapter may be needed to finish
the connection to the stove.
TEE
REDUCCTION
COLLAR OR
TRIMCOLLAR
fig. Nº9
-14-