If Stove Runs Out Of Pellets; Refueling; Shutdown Procedures; Safety Features - Bosca SPIRIT 500 Installation And Operating Instructions Manual

OWNER´S MANUAL
IF STOVE RUN OUT OF PELLETS
The fire goes out and the auger motor and blowers will run until the stove cools. This will take
30 to 45 minutes. After the stove components stop running, the "Power" and the BAR GRAPH
lights stay on for 10 minutes. After the 10 minutes the "3" light on the bar graph will flash and
the "Power" light will go off. To restart, refill hopper, press "Power" button, and then press "Fuel
Feed" button until pellets begin to fall into burnpot.

REFUELING

We recommend that you not let the hopper drop below 1/4 full.
KEEP HOPPER LID CLOSED AT ALL TIMES EXCEPT WHEN REFILLING.

SHUTDOWN PROCEDURES

Turning your BOSCA SPIRIT 500 PELLET STOVE off is a matter of pressing the "Power" control
panel switch. The red light will go out. The blowers will continue to operate until internal
firebox temperatures have fallen to a preset level.

SAFETY FEATURES

A.- Your stove is equipped with a high temperature thermodisc. This safety switch has
two functions:
1. To recognize an overheat situation in the stove and shut down the fuel feed or
auger system.
2. In case of a malfunctioning convection blower, the high-temperature thermodisc will
a u t o m a t i c a l l y s h u t d o w n t h e a u g e r , p r e v e n t i n g t h e s t o v e f r o m o v e r h e a t i n g .
NOTE: On some units, once tripped, like circuit breaker, the reset button will have to
be pushed before restarting your stove. On other units the thermodisc has no reset
button and will reset itself once the stove has cooled. The manufacturer recommends that you call
your dealer if this occurs as this may indicate a more serious problem. A service call may be
required.
B.- If the combustion blower fails, an air pressure switch will automatically shut down
he auger.
N O T E : O p e n i n g t h e s t o v e d o o r f o r m o r e t h a n 3 0 s e c o n d s d u r i n g o p e r a t i o n w i l l
cause enough pressure change to activate the air switch, shutting the fuel feed off. Close the door
and press "On/Off" button to continue operation of your stove.
IF LEFT OPEN AUGER WILL NOT FEED.
DO NOT OVERFILL HOPPER.
-21-