Bosca SPIRIT 500 Installation And Operating Instructions Manual page 24

OWNER´S MANUAL
MODES
To switch between any of the three modes the stove must be shut off, the new mode selected,
and the stove restarted.
MANUAL MODE
(see fig. Nº14 a)
In this mode, the stove will operate only from the Control Panel, as detailed in the "OPERATION"
section of this Owner's Manual.
HIGH/LOW THERMOSTAT MODE
(see fig. Nº14 b)
When engaged in this mode, the stove will automatically switch between two settings. When
warm enough, it will switch to the #1 or low setting. The room air blower will also slow to its
lowest speed.
The Heat Level Advance setting on the bar graph will stay where it was initially set. When the
house cools below the thermostat, the stove will switch to the feed rate of the heat level advance
setting.
ON/OFF THERMOSTAT MODE
(see fig. Nº14 c)
In this mode when the home is warm enough the stove will shut off. The fans will continue to
run until the stove cools.
When the home cools below the thermostat setting, the stove will automatically restart and run
at the last feed rate setting.
MANUAL
T-STAT
AUTO
fig. Nº14 a
NOTE: When in "High/Low" or "On/Off" thermostat mode, do not operate the stove higher
than the #3 setting.
Set damper control rod approximately 1/2" to 3/4" out. This will vary depending on elevation
and weather conditions.
Observe stove's operation and adjust damper
HIGH/LOW
MANUAL
AUGER
TRIM
T-STAT
MANUAL
AUTO
AUGER
TRIM
fig. Nº14 b
ON / OFF
T-STAT
AUTO
MANUAL
AUGER
TRIM
fig. Nº14 c
-23-