HP EliteBook User Manual page 121

26. Align the switch cover, and then press down on the switch cover locations, making sure that the
switch cover hooks snap into place.
NOTE: If there are bumps or raised areas on the switch cover, remove the switch cover and
repeat this step.
27. Close the display.
28. Turn the computer upside down on a flat surface.
29. Tighten the 4 keyboard access screws (1).
30. Replace the 3 switch cover screws (2).
31. Align the tabs (1) on the hard drive cover with the notches on the computer.
32. Lower the cover (2), and then press down on the cover to snap it into place.
Upgrading a memory module in the primary memory module slot 109