Satellite Receivers Installation - Hangar 9 Extra 300 ARF Assembly Manual

Satellite Receiver Installation
Required Parts
Fuselage
Required Parts (not included)
(3 to 4) Satellite receivers
Required Tools and Adhesives
Double-sided tape Masking tape
Hook and loop
Medium CA
Note: It is best to use 4 satellite receivers as this is
a large model. However, with proper placement of
the satellite receivers, 3 would be adequate. A Flight
Log can help with correct placement of the satellite
receivers. Check the health of the system before first
flight.

1. There are two ways to mount the satellite receivers.
One way is to simply apply a piece of double-sided/
servo tape to the back of the satellite receiver and attach
to the fuselage. See step 3 for the alternative method.
36
Location of Satellite receiver 1.
Location of Satellite receiver 2 - side of the fuselage
tunnel.
Location of Satellite receiver3 - front of the tank and on
the left vertical side.
Location of Satellite receiver 4 - front of the tank and on
the right vertical side.

2. Attach a piece of masking tape to the back of the
satellite receiver; apply a couple of drops of CA to the
masking tape and stick a piece of hook and loop to the
masking tape. Note that even if the hook and loop is
adhesive-backed, CA helps hold the hook and loop to the
masking tape in high temperatures.
35% Extra 300 ARF Assembly Manual