Hangar 9 Extra 300 ARF Assembly Manual page 30


5. Cut the opposite side of hook and loop to the ignition
module and glue to the engine box.

6. Cut a piece from the hook and loop roll provided in the
kit and strap the ignition module in place.

7. Apply a piece of masking tape to the bottom of the
ignition regulator.
30

8. Glue a piece of industrial-strength hook and loop using
medium CA to the back of the regulator over the masking
tape.

9. Apply some medium CA to the former where the
ignition regulator will be mounted and glue the opposite side
of the hook and loop.

10. Mount the regulator.

11. Ignition switch mount is already installed at the side
of the fuselage. Remove the covering where the ignition
switch will be mounted.
35% Extra 300 ARF Assembly Manual