Figure 92 - Recovery Options Page - Motorola PTP 500 Series User Manual

Clicking on the warning page image will take the user on to the Recovery Option Page
(Figure 92).
The recovery options available are:
Upgrade Software Image
This allows the user to reload a software image. This may be the original image if software
corruption is suspected or a step back to an old image if an incorrect image has just been
loaded.
Reset IP & Ethernet Configuration back to factory defaults
This allows the user to reset the unit back to the factory defaults:
IP Address
Netmask
Gateway
Ethernet Interface
Erase Configuration
This allows the user to erase the unit's entire configuration. Executing this option will also
erase factory settings such as target MAC address, range setting, license key, etc.
Zeroise Critical Security Parameters
This allows the user to erase the security parameters such as AES parameters.
Reboot
This allows the user to reboot the unit. This option must be executed after resetting the IP &
Ethernet configuration or erasing the configuration detailed above.
Software Version
This is the software version of the recovery operating system permanently installed during
manufacture.

Figure 92 - Recovery Options Page

169.254.1.1 (or 10.10.10.10)
255.255.0.0
169.254.1.0
Auto-negotiate, Auto-MDI/MDIX
152
8 Recovery Mode