Table of Contents

Advertisement

26
SMOOTH CE3.0 XT ELLIPTICAL
STRIDE ADJUSTMENT
VST STRIDE ADJUSTMENTADJUSTMENT:
The CE 3.0 XT is equipped with a manual stride adjustment. This feature allows you to adjust the stride length to what
is most comfortable for you.
To adjust the stride, locate the VST adjust know located in the front of the elliptical on the center upright post. Once
the knob is located turn the knob counter clockwise to loosen the knob them pull the knob outwards. While holding the
know outwards slide the knob up or down through the 4 different settings. When the adjuster arrow is aligned with the
desired stride length release the knob. Verify the knob is locked I place them turn the knob clockwise to tighten the
stride adjuster assembly.
NOTE: Improper alignment and tensioning of the adjuster knob may cause noise and incorrect movement.
ADJUSTER ARROW
Although; this case is very unusual, the adjuster arrow may need to be calibrated. To calibrate the arrow, set the stride
adjuster to the smallest stride. This setting can be obtained by sliding the adjuster knob upward to its furthest position.
Now reset the arrow to the first/smallest stride length

Advertisement

Table of Contents
loading

Table of Contents