Control Panel - GE Profile WPDH8800J Technical Service Manual

Control Panel

The control panel is held in place with 5 Phillips-
head screws and 1 tab.
To remove the control panel assembly:
1. Remove the top panel. (See
2. Pull the dispenser out to the stop position. Press
down on the lock tab. Pull the dispenser out.
3. Remove the 2 Phillips-head screws from the
control panel dispenser recess.
4. Remove the 3 (7-mm) hex-head screws that
attach the top of the control panel to the control
panel brace.
Rear View
.)
Top Panel
Lock Tab
– 23 –
5. Lift the top edge of the panel to disengage the
tab that holds the top of the panel in place.
Tab
6. Lift the panel from the cabinet.
7. Disconnect the wire harness from the control
panel.
Note: When installing the control panel, place the
panel pin in the locator hole in the top right-side of
the front panel before engaging the tab.