5.
On the inverter board, check for an approximate
resistance value of 6 ohms between any two of
the three terminals:
•
A to B (Blue to white) - 6
•
A to C (Blue to red) - 6
•
B to C (White to red) - 6
C
B
A
Note: The sensor and sensor wiring can be checked
at the power board assembly. Check for a resistance
value of approximately 118 Ω resistance between
the 2 yellow wires located on the wire harness
located at J79.
J79
Ω
Ω
Ω
To remove the motor:
1.
Remove the belt. (See
2.
Remove the
/
-in. bolt from the threaded plate
1
2
that holds the motor arm to the outer tub.
Motor Arm
Slot
Plate
•
The threaded plate can fall out of the recessed
slot in the motor mount. Ensure this plate is
reinserted in the slot upon reassembly.
•
When reinstalling bolt, apply Locktite (Part #
WX5X1005) to bolt threads. Ensure motor arm
is at lowest position under motor bolt before
tightening.
– 41 –
.)
Belt
Note
(Continued Next Page)