GE Profile WPDH8800J Technical Service Manual page 29

Note: An inlet tube is placed between the inlet hose
and the dispenser tank. The inlet tube provides
proper water pressure to the dispenser and nozzle.
When removing the inlet hose, the inlet tube may
remain in the hose. Ensure the inlet tube is fully
inserted into the tank inlet upon reassembly.
Inlet Hose
Inlet Tube
Tank Inlet
Dispenser
Vent Hose
Bulk Dispenser
Inlet Hoses
Bulk Hose Connections to Dispenser Tank
Middle Hose
Note: Install the dispenser vent hose with the notch
aligned on dispenser tank. Ensure that the seam
remains aligned with the pointer on the outer tub.
6. Using either a Phillips-head screwdriver or a
Note: Install the dispenser outlet hose with the hose
indicator aligned with the dispenser tank protusion.
Top Hose
Bottom Hose
– 29 –
Notch
7-mm hex-head nut driver, loosen the clamp
and remove the dispenser outlet hose from the
dispenser.
Dispenser
Outlet Hose
Seam
Pointer
Protrusion
Indicator
(Continued Next Page)