GE Profile WPDH8800J Technical Service Manual page 58

Error Code
E22 Over Volts Motor Drive Internal
Problems
E23 Under Volts
E24 Under Volts
After Start
E25 Power Up
E3 Inverter EEPROM
Fault Event
E17 ADC Fault Event
E26 LIN Comm Fail There is a
problem with the
Communication
between the Machine
Control and the User
Interface Control
Description
• Measure AC outlet voltage; ensure correct range (120V to
132V AC).
• Check electrical connections at the motor drive.
• Check harness integrity between main control and
motor drive.
• Unplug the unit, wait 30 seconds and restart the unit.
• If the fault persists and reappears, replace the motor
drive.
• Check the integrity of the wiring between the Machine
Control Board and the User Interface.
• Clear the fault and run the cycle. If fault persists and
reappears, replace the Machine Control.
– 58 –
Action